Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MIDDEN1 on December 09, 2012, 02:13:31 PM
-
running mach3 with gecko g540 drive 200 step steppers
just bought new machine with 5mm pitch ball screws they gave me thier xml file for mach3, native units is inch, motor tunning steps per is set at 2032
does not seem correct to my calculation 200*10/.19685 =10160.020
what one is correct
-
Does the machine move correctly with their XML?
(;-) TP
-
not up and running yet
-
Neither but you are closer ;)
It should be 10160 exactly.
Hood
-
thankyou
very much for reply i will go with that
-
Your mistake was using .19685 instead of 0.19685039370078700000000000000000000000.