Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: powermatt on December 05, 2012, 12:39:01 AM

Title: looking for a little help in MN
Post by: powermatt on December 05, 2012, 12:39:01 AM

I am wondering if there is any Mach 3 users here in MN?  I am looking for some help to get up and running and thought it might be better to try to find someone close?

I seem to have everything up and running but am sure thing could be done better.

I currently have a very simple gcode file that is not running correct on my machine.  It may just be the way the code was written but not sure.  If anyone would be willing to take a look please let me know.  I am at a loss until I can figure out what is going on here.

Thanks,

Matt
612-490-5696

Title: Re: looking for a little help in MN
Post by: powermatt on December 05, 2012, 07:58:50 PM

Wow, not one response???

Title: Re: looking for a little help in MN
Post by: RICH on December 05, 2012, 10:08:38 PM

Post the gcode file.
Also post the xml file you are using.
RICH