Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: eelmans on November 23, 2012, 01:50:03 AM

Title: used encoder for feedback
Post by: eelmans on November 23, 2012, 01:50:03 AM

I'm going to use the encoder for feedback on  x,y axes. So the encoder position of  axes appear directly to axes DRO.
What should I do?

Title: Re: used encoder for feedback
Post by: Hood on November 23, 2012, 02:59:33 AM

If you are meaning axis DROs then you cant, if you are meaning encoder DROs then just put the encoders A and B channel to 2 spare inputs and configure them as the encoder inputs. Note that this will only be a visual thing as Mach will not act on encoder input.
Hood

Title: Re: used encoder for feedback
Post by: eelmans on November 23, 2012, 06:00:40 AM

I want to count axis DRO with encoder pulse and No with calculation.
for example ,
X Axis will continue to move until X position Encoder  reaches to the destination coordinates .

Title: Re: used encoder for feedback
Post by: eelmans on November 26, 2012, 06:01:36 AM

Who is accountable?

Title: Re: used encoder for feedback
Post by: Hood on November 26, 2012, 06:35:36 AM

Quote from: eelmans on November 26, 2012, 06:01:36 AM

Who is accountable?

No one as far as you are concerned. You are using a pirate licence and you have the cheek to come here for help. I will not give you any and others have said the same in your other posts.
Hood

Title: Re: used encoder for feedback
Post by: RICH on November 26, 2012, 12:23:00 PM

eelmans,
You were warned a few days ago via a personnel message. What words did you not understand?

Quote

I would apreciate that you understand  we don't condone or "support" illegal users.

RICH