Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: widpyro on November 21, 2012, 05:48:43 PM

Title: Getting motors to run opposite direction
Post by: widpyro on November 21, 2012, 05:48:43 PM

I just replaced the computer I was using with Mach3 (and smooth stepper) and the motors now run the opposite direction than the used to. Is the an easy fix without re-wiring?
Jim

Title: Re: Getting motors to run opposite direction
Post by: ger21 on November 21, 2012, 05:55:30 PM

Config >Homing/Limits and check the "Reverse" column.

Title: Re: Getting motors to run opposite direction
Post by: Richard Hallett on March 12, 2013, 11:13:42 AM

Genuis....To a newbie to CNC..such information is valuable. Many thanks