Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: dsplastx on November 11, 2012, 08:15:07 AM

Title: How to conect motors
Post by: dsplastx on November 11, 2012, 08:15:07 AM

Hello i hawe problems to post a mesage with atached pics.

http://postimage.org/image/y6lg5fs01/
http://postimage.org/image/75cginql3/
http://postimage.org/image/4696iuyn1/

Title: Re: How to conect motors
Post by: RICH on November 11, 2012, 08:38:35 AM

If the image size is too large it will not post.
RICH

Title: Re: How to conect motors
Post by: dsplastx on November 11, 2012, 08:42:46 AM

Ok now its ok .
So the problem is .
I haw this motors on mu machine and i get a new toshiba driver board but i have 8 wires on mu motors like i posted on the image with this color codes that i posted on image but on the board i haw only 4wire convection .
I haw traing to connect the motors parallel and serial to get 4 wires but when i turn on the driver from the motor is coming wery high ferkwecy small sound and aftr 30sec the safety relay on the board komes up and i hawe to wait until he gets coold.
Or maybu i make some mistake with the jumpes on the board or something else.
Can somebody hellp me how to conect it propertly on the board. fell free to take my droving and redraw on the drowing how to conect the motor and hov to adjust the jumpers .
Thanks in advance.