Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: celticbern on January 25, 2007, 06:04:17 AM
-
Hello,
I am having problems with the Cutter Comp on my Celtic Wine Racks....
I set it to "Comp Left" on the BobCad v20 program side and create the G-code. At some point when I am running it on my CNC machine the cutter comp seems to lose where it is going.
I know the basics only....Can I turn off the cutter comp somewhere in the "Config menu" on Mach 3 ???
thanks
bernie
http://www.carvingceltic.com
-
Cutter comp. is only active if you have a G41 or G42 in your program.
Graham.
-
I have the G41 (comp left) in the G-Code....
it still runs off
-
I had the same problem with version 2 so I reverted back to 1.9 and cutter comp works fine.
http://www.machsupport.com/forum/index.php?topic=2258.0
-
If you don't want to run the program with cutter comp simply use the diamerter "Zero" in the tool table for your tool.
Immo
-
I have the G41 (comp left) in the G-Code....
it still runs off
Can you post the code?
If you don't want to use the comp, you'll need to not use it in BobCAD.