Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rafterj on November 06, 2012, 03:58:44 PM
-
I don't know what this means. When the message appears the light next to the Z-axis readout turns from green to red and the z-axis on the table goes all the way up. I can reference all axis, switch to the coordinates button and sometimes I will not get the message and all is good and then the next time its not. I have an EZ-Router APC plasma table. Any and all assistance is greatly appreciated.
-
It is saying the HOME switch is already active (stuck maybe) when you called the refhome function. It then says FIX the active condition and then ref home.
(;-) TP
-
HOME switch? is that the limit trigger switch on the Z-axis?
-
Can't see your machine so you are the only one that might know(;-).
(;-) TP
-
I have some extra switches, should I try to replace the one on the z-axis and the re-reference the table. I have referenced the table a couple of times since this started and it will work right for sometimes 1 or sometimes up to 50 cuts but then the messages will come back.