Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: tantan on November 04, 2012, 03:28:33 AM

Title: softlimits and 4th axis
Post by: tantan on November 04, 2012, 03:28:33 AM

hi,

in general config there is an option to turn on/off softlimits for the fourth axis (rotational: rotational softlimits). this does not seem to work. if you turn softlimits on the softlimits for the fourth axis are enabled, no mather if the rotational limits are checked on or off.

tnx TanTan

Title: Re: softlimits and 4th axis
Post by: Fastest1 on November 10, 2012, 03:35:39 PM

I was under the impression and I could be wrong, the rotational limits in regards to the dro resetting as it passes 360 degrees. Not sure about the soft limits aspect though wouldnt the actual soft limit for the particaular axis be in motor home and soft limits set up page?