Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: BDGSimon on November 01, 2012, 09:59:07 PM
-
Hi All,
I am in the process of converting an old lathe that i have purchased to DSPMC/Mach3 control. I have noticed that rather than the typical 0-10V analouge speed control the controller for the spindle motor runs makes use of a 12-bit digital value to control the speed of the spindle...
I am thinking that i could use brains or write a plug-in to output the according 12 bit value over some of the output ports of my DSPMC controller.
Does this seem reasonable, does anyone know of a similar instance of this that they could refer me to or have any suggestions on the best way to tackle my problem?
Thanks,
Simon