Machsupport Forum

Third party software and hardware support forums. => Promote and discuss your product => Topic started by: lsces on January 23, 2007, 05:35:35 PM

Title: United Kingdom Mach3 Support Mach-in-a-box
Post by: lsces on January 23, 2007, 05:35:35 PM

As part of the Model Engineers Digital Woirkshop range of products I am supplying per-configured ITX based computers with a fully licenced copy of Mach3 already installed. These are configured for either the MicroMill Taig controller, or the C11 breakot board, and can be configured for any other target controller as required.
http://medw.co.uk/wiki/?page=Mach-in-a-box (http://medw.co.uk/wiki/?page=Mach-in-a-box)
(http://medw.co.uk/storage/attachments/219/219/cn13000_alt1_large.jpg)

Title: Re: United Kingdom Mach3 Support Mach-in-a-box
Post by: lsces on June 19, 2009, 03:55:46 AM

Slowly getting to a complete packaged system
http://medw.co.uk/articles/read.php?article_id=12 (http://medw.co.uk/articles/read.php?article_id=12)
(http://medw.co.uk/storage/attachments/169/1169/MEDW1000-Front.JPG)