Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: vtx1029 on October 20, 2012, 05:41:43 PM

Title: Homing question
Post by: vtx1029 on October 20, 2012, 05:41:43 PM
I have a router with a motor on each side of the gantry (Y axis on the left and A axis on the right) and want to use 2 home switches to auto square the gantry. My question is lets say I find that my gantry is not square and I want to adjust the Y by .005 is there away I can adjust that in mach 3 to do a move instead of moving my Y axis home sensor? I was trying to use the distance off switch but any number I put in there just changes the DRO and does not actually move the axis.
Title: Re: Homing question
Post by: ger21 on October 20, 2012, 06:16:21 PM
You'll need to move the switches until it's square.