Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: smithvac on October 19, 2012, 06:31:47 PM
-
Hi
I am a new user and I have a rotary axis (a) that seems to have a limit. I can go so far then it stops and only allows me to go the opposite direction.
What settings do I need to change to make it rotate indefinitely.
Any help would be appreciated.
-
Sounds like you may have a soft limit set for the A axis .
(;-) TP
-
Yes as TP says you likely have the rotational; soft limits enabled, you will find that option on General Config page near the lower middle right section of that page.
Hood
-
Thanks
I will have a look
-
Hi I turned off the rotational soft limits and restarted the software. It did't change.
-
Can you attach your xml and I will have a look.
Hood