Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dodiano on January 23, 2007, 03:20:47 PM
-
Hi there,
I have been cutting some Plastic pieces with my machine using MACH 2, now I use some Enco bits which have been cutting fine and I know my offset for the tool is 0.15 inches... Somehow I started cutting a piece taking into account the offset as always and it basically was off on all sides by 0.125 inches! It happened before once machine cutted a different measurement after I reset it and turn everything off all of a sudden cuts back again as it should!! ANy ideas?? Hven´t tried recutting the part.
Regards,
Roberto
-
Are you using G41/42, if so have you got a G40 at the end of the program.
Graham.
-
Nope! No G40 anywhere... Nor g41/42
Regards,
Roberto
-
Sound as if you should be trying Mach3.
-
But is weird cause it was working normally I´ve been working the hole week with it no Fuzz!!
-
Could you please update your machine to Mach3. It is getting hard to trouble shoot mach2 at this time for problems like that.
You can have mach2 and 3 on the same machine with no trouble
Thanks
Brian