Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rcrabb on January 23, 2007, 09:29:48 AM

Title: Radius Comp
Post by: rcrabb on January 23, 2007, 09:29:48 AM

My radius comp LED always on. I can't seem to get it turned off. I checked the XML and radius comp off is 1. I also made sure the LED on the screenset is asigned the correct OEMLED value. Any ideas????????????????????????

Title: Re: Radius Comp
Post by: Chaoticone on January 23, 2007, 09:41:46 AM

Hey Ryan,
    Is it doing this while you have code loaded? Is there a G41 or G42 in your code?

Brett

Title: Re: Radius Comp
Post by: rcrabb on January 23, 2007, 09:45:48 AM

No code loaded. I even did A G40.

Title: Re: Radius Comp
Post by: Chaoticone on January 23, 2007, 09:53:41 AM

In general config, ports and pins, mill options, is advanced compensation on in there?

Brett

Title: Re: Radius Comp
Post by: rcrabb on January 23, 2007, 10:59:43 AM

I turned it off and the radius comp LED is still on. Even resarted mach and did a G40.

Title: Re: Radius Comp
Post by: Chaoticone on January 23, 2007, 11:10:46 AM

What version of Mach are you running Ryan? I will do some test tonight.


Brett

Title: Re: Radius Comp
Post by: rcrabb on January 23, 2007, 01:47:01 PM

2.0.038