Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: alonzo83 on October 11, 2012, 11:09:08 AM
-
Hi there
I am hooking up mach 3 to a probotix pbx-2 3 axis kit. I have set the ports and pins to probotix's specs, I have made sure the parallel port address is correct. I have checked to make sure the max nc is not turned on. I did the driver test and it is good to excellent.
The only thing I can think of is re install windows xp and mach 3.
Do any of you have any other suggestions?
Thank you, Alonzo
-
cancel that. I discovered that a probotix board will ont function if one of the drivers is shot. I unglugged the x axis on the bob and the stepper motor came to life.