Machsupport Forum
Mach Discussion => Mach SDK plugin questions and answers. => Topic started by: budman68 on September 29, 2012, 03:35:51 PM
-
Hi, guys,
Can anyone please tell me why I would be getting these message boxes before Mach3 finishes starting up?
First popup box: Plugin dll defective. Reload (I then click ok and it goes away)
Second popup box: LCDDRO.dll defective plugin found. Ignoring...(I then click ok and it goes away)
Mach 3 loads fine but when I go to configure plugins, the LCDDRO plugin is not there, which is obviously what it was telling me when it first loaded up. ;D
This plugin is working properly on my other systems (same rev) but for some reason, on my router setup, it is not working.
Any thoughts?
Thanks,
Dave
-
Nevermind, I figured it out. My XP version was too old as I needed the SP2 upgrade and also 3.5 NET install as well.
Hope this helps others someday-
Dave