Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: BOATDUDEGUY on September 24, 2012, 06:40:11 PM

Title: WORK/ TOOL OFFSETS
Post by: BOATDUDEGUY on September 24, 2012, 06:40:11 PM

HOW DO I SAVE THEM?

Title: Re: WORK/ TOOL OFFSETS
Post by: RICH on September 24, 2012, 07:00:57 PM

When in the offsets table click the save button.  Save settings, also in general config there are DRO settings  ( lower right of the screen) and you can select if you wnat to be prompted to save the offsets ( doing this from memory so look at the manual ).
Some gcodes will cancell out the offsets and same goes for a initialization  macro, if using one, on startup.