Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: newatcnc on September 21, 2012, 09:17:32 AM
-
Hi everyone.
Anyone got any recommendations for getting started in 3d probing. Software, hardware etc.
I have been doing a little research but so far still at the slightly confused stage.
I have seen plenty reference to Mach Cloud but there does not seem to be a down load any more?
I want to be able to probe a 3d curved shapes and scale them up or down for creating G-code (or maybe I can use the scale facility in mach3 next to the DRO's?)
Any suggestions, experience and help very much appreciated.
Thanks
Nigel
-
Mach Cloud. http://www.machsupport.com/downloads/MachCloud.zip