Machsupport Forum

Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: peterc on September 20, 2012, 08:13:52 PM

Title: Mach 3 Kernel Speed
Post by: peterc on September 20, 2012, 08:13:52 PM

Does the Mach 3 Kernel speed affect the dspMC operation?
I have mine set at 25K.

Title: Re: Mach 3 Kernel Speed
Post by: TOTALLYRC on September 22, 2012, 01:13:53 PM

Hi Peter,
IIRC it makes no difference. In the case of some external controllers changing it used to cause trouble so just leave it at 25k.
That setting is really only for the pport.

Mike