Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: phillip t on September 17, 2012, 05:28:34 AM

Title: Gecko G540 With C3R6 Index Pulse Board - Help Needed
Post by: phillip t on September 17, 2012, 05:28:34 AM
I have been using Mach3 for years. I am a newbe to the forums. Now I am getting into threading with Mach3. I am trying to get my C3 Pulse Indexer to work in Mach3 with a Gecko G540.
My question is this,
Shouldn't I see a light flashing on the diagnostics page when I rotate my spindle?
Thank's
phillip