Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: faby on January 18, 2007, 05:32:29 AM
-
Hi there i have a Shuttlepro v2 as pendant, when I turn the center wheel as single step mode, it produces at most 5-6 pulses per second, and it move so slow.
I have only mach3 plugin installed to drive the shuttlepro, no other software and I'm using the 2.037 version.
It's normal or it could generate more pulse/sec?
Thanks to all
Faby
-
We do this because we don't want to miss steps.... If every one ran servos with Accels set at 150in/sec^2 we could give you the faster rate :)
Sorry
Brian
-
ok thank you..
it was not a problem only a curiosity... ;)
Faby
-
No problem!