Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: roman on September 03, 2012, 07:20:31 PM

Title: mach 3 probs
Post by: roman on September 03, 2012, 07:20:31 PM

ok i am getting my plasma table going , when i use jog keys they only run one way! on the screen it shows the numbers changing both ways but motors only go one way

Title: Re: mach 3 probs
Post by: Tweakie.CNC on September 04, 2012, 01:34:40 AM

Hi Roman,

First thing to check is that you have the Direction pin configured correctly in Config / Ports and Pins / Motor Outputs.

Tweakie.