Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: hassse.w on August 27, 2012, 05:30:17 AM
-
Hi
I plan to run a Lathe with Pokeys 56U.
Did some small tests, it worked very good but a have some small problems sure a do somthing wrong.
I run the MPG with ( lets pokeys handle MPG) .
if a run it with mouse on jog +x it go -x it works ok iif a config as paralell but when config as pokeys pulse engine it reversed,
i can change the direction on the motors , i suspect that wy softlimits not work for me.
and a can not zero X ort Z after that a turn on mpg but as long a in cont mode a can zero but not after i get into mpg mode.
What i doing wrong?
I run Mach3 on a mill and router the last 5 years.
For the Lathe its Win XP 32 SP3, Pokeys last firmware and plugin , mach3 Version R3.043.062
Kind Regards / Hasse
-
Hi, Hasse
I lost you here:
, i suspect that wy softlimits not work for me.
and a can not zero X ort Z after that a turn on mpg but as long a in cont mode a can zero but not after i get into mpg mode.
Can you explain this little more?
Regards,
Matevž, PoLabs
-
When a want to Zero part with Button 1008: Zero X for example.
I can do that if a start with Cont mode on the screen MPG, but when a go to MPG mode and turn the encoder,
after that a cant zero any more even in Cont mode.
The softlimit most have something to do with the direction if jog X+ it go X- in pokeys mode.
the limits and direction works for me in paralell mode?
Regards/ Hasse
-
It's hard for me to decode your writing if you keep substituting I with a.
Do you have MPGs handled directly by PoKeys or do you have MPG only connected to PoKeys and Mach3 does the handling?
-
Hi
My Eng is very bad ???
I build a Lathe and i have 2 pokeys as spare for my 737simulator, i have total 7 Pokeys 56U.
If it not work a swap it to a C10 paralell no big deal, but a love this card for the sim
I made a short video clip no hiigh quality its from the phone.
http://www.youtube.com/watch?v=91kjtNih7HQ (http://www.youtube.com/watch?v=91kjtNih7HQ)
-
We will check this and will let you know.