Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: woodspinner on August 18, 2012, 11:15:22 PM
-
I used to use an old version of mach, when I hit feedhold I could jog away and do whatever, then hit cycle start and it would do a preperatory move and wait for cycle start. after upgrading to Mach3 R3.043.022, i find it doesnt work anymore, no preperatory move, simply executes the next block. Which version do i need to upgrade to where this is fixed? While I'm at it, which dev version are pretty stable?
John
-
Should work fine with almost any version. Its maybe a config issue, if you attach your xml I will have a look.
Hood
-
Here it is.
thanks for looking at it
John
-
I wanted to say, I upgraded to Mach3 R3.043.062, and it seems to be fixed in this release. How stable is it?
John
-
Just tried with your xml and its working fine. What version are you using and I will test with that.
Hood
Edit see you have just replied, 062 should be stable enough.
-
I was using Mach3 R3.043.022 when I found the issue, I upgraded to Mach3 R3.043.062 and it was working again.
I had previously used Mach3 R3.043.062, and had it set to 35k kernel speed, the machine was unreliable so I quickly swapped to .022 and reset kernel speed to 25k that worked for a time but I think the problem was the computer and the xp installation that created most of my issues so yesterday I reinstalled xp with .022 and then thought better of it given my issues with the feed hold. I just dont want to invest another several hours cutting only to have some new issue raise its ugly head.
John
-
I use that version on one of the mills and it runs fine for me and has done for a good while so hopefully it will work fine for you.
Hood