Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: dareng on August 10, 2012, 05:18:40 PM

Title: Z AXIS WILL NOT HOME
Post by: dareng on August 10, 2012, 05:18:40 PM
HI THERE                                                                                                                                                                                                                                             I CANT FIGURE THIS ONE OUT,X AND Y AXIS HOME PERFECTLY AND Z WILL NOT DO ANY THING WHEN REF ALL IS PRESSED. I AM TRYING TO GET MY THC300 GOING AND HAVING LOTS OF PROBLEMS, HOPING  ALL MY FOULT

 ANY SUGGESTIONS WOULD BE GREAT
 
                                                                        DARREN
Title: Re: Z AXIS WILL NOT HOME
Post by: Hood on August 10, 2012, 06:15:02 PM
Dont know anything abut the THC300, is the homing done in a plugin or is it Mach that handles it? If Mach then it would seem you do not have a Home switch defined for the Z.
Hood
Title: Re: Z AXIS WILL NOT HOME
Post by: dareng on August 15, 2012, 11:09:05 PM
Thanks for your reply Hood

I think I got it figured out, but I'm sure I'll be back for 1000 more questions

                                                                   Thanks Darren