Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Fountaine on August 06, 2012, 03:35:04 PM

Title: M Codes
Post by: Fountaine on August 06, 2012, 03:35:04 PM

I am using plasma for the first time.  I have to fire the torch manually in the Mach screen.  I expected it to toggle to the start point and fire automatically when it hit the start point of the design.

Instead I have to fire it and it drags over to the start point and starts it's code run.

Does anyone know the M Codes I need to generate to fire at the start point? Is there something else I might be missing?

Am I right or wrong on it firing at the start point of the design on it's own?

Title: Re: M Codes
Post by: schlegelrock on April 15, 2013, 08:51:47 PM

I am having the same problem. Did you ever find a solution?

Title: Re: M Codes
Post by: Chaoticone on April 16, 2013, 12:03:01 AM

Sorry I missed this, you will find a lot of information by going to the link below and doing a search for THC.

http://www.machsupport.com/docs/Mach3Mill_Install_Config.pdf

Brett