Machsupport Forum
Third party software and hardware support forums. => SmoothStepper USB => Topic started by: tantan on August 06, 2012, 01:38:55 PM
-
hi all,
when i start mach, i used to become a dialogscreen where i could select if i want to use the smoothstepper or normal printer port operation. i still get the screen in turn but not in mill. can i switch it on again somewhere in mill?
tnx,
tantan
-
Function Config menu then choose Reset Device Select. You will now get the selection next time you start Mach.
Hood
-
Spot on hood, tnx!
Tantan