Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: abhi on August 02, 2012, 05:14:30 AM

Title: quick question re axis formulas
Post by: abhi on August 02, 2012, 05:14:30 AM
can anyone tell me if the axis formula(s) operate from machine coordinates or from G54 offset?
Title: Re: quick question re axis formulas
Post by: abhi on August 02, 2012, 11:30:32 PM
eargh....

I've managed to confirm that axis formulas operate relative to the work offset rather than machine coordinate system :( sadly this renders non linear table correction useless. Back to the drawing board.