Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: otpco on July 20, 2012, 07:06:45 PM
-
Hi all I need some ideas for mu moog project . I need to park the spindle at a n exact rotational spot . Maybee adding another optical index sensor and somehow hooking it to the VDF and doing a jog or something .I am fishing for ideas thanks mark
-
Probably the easiest way would be to use a shot pin of some sort if you can mount such a thing. You would rotate the spindle slowly and release the pin and whan it came round to the hole it would pop in and lock the spindle. You could have a limit switch to show when it was engaged (and disengaged) and that could then be used to stop the VFD.
Hood
-
Otpco. Which moog do you have? I am starting on a b-22
Steve
-
hi steve no idea but an early one have been working on it for years . have taken heaps of scrap away ! mine is green . and a Q@C30 taper 25 turret tool changer ,now servoes all round .vfd drive no vari belt ( thank god) just looking intp the tool changer .its a bag of worms i can change it via switches just getting into how to automate it . Drawbar works on air using all the original bits but no oil