Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: Nitromuse on July 16, 2012, 06:08:36 PM
-
Hello world,
I've written a new macro that runs just fine from the script editor but won't run from the input in MDI like all the existing other .m1s files do.
Que pasa?
Thanks,
-
You'll need to post the macro if you want someone to tell you why it's not working.
-
here's the macro at this point;
thanks again
-
You need to move your macro OUT of the M1-100 range. Mach sees it as an internal macro and cannot find it.
Nice macro by the way(;-)
(;-) TP
-
Thanks for the reply. Actually I just tried renaming it to M22 instead if M2 and it ran fine from the MDI. So there must be some reserved macro numbers, does anyone know if and where this is documented. Thanks again,