Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Newuser1 on July 11, 2012, 02:28:56 PM
-
Hi,
I'm running into a problem where everything past line 150 of my gCode is being cut-off(not viewable in the mach gcode cycle view) however whatever is line 150 in my g-code seems to be duplicated four times in machs gcode window however it isn't in the actual .tap file
Anyone run into this before?
-
I presume this is a lathe and you are hitting the max line count of the demo. On a mill it is 500 lines before you hit the max line count of the demo.
Hood
-
How do I configure a license, by simply placing it into the Mach3 directory? My Mach does state that it is licensed.
-
Thats all you need to do so not sure why you have hit the line limit then.
If you attach your xml and your code I will see if I can replicate the problem here and hopefullt find the issue.
Hood
-
Hi,
After doing a fresh reboot the problem fixed itself, thanks!
Thats all you need to do so not sure why you have hit the line limit then.
If you attach your xml and your code I will see if I can replicate the problem here and hopefullt find the issue.
Hood