Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bigbearzfan on July 07, 2012, 01:53:55 PM
-
I have X movement but no DRO for X, Y and Z are fine. I have rebooted several times. What next
-
Attach your xml please, its likely something in your config.
Hood
-
Do you have something specific I can look for. My table is on a different computer at my shop. I dont have internet access there so I am trying to come up with solutions so when go back there I will have something to try.
Thanks for any help.
-
I wont know until I look at the xml.
Hood