Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: diyengineer on June 13, 2012, 10:20:27 PM
-
So the probe works, and when triggered the digitize light comes on.
What i can't figure out is how to work the digitize wizard.
It gives a Z- command but instead of probing down to my table it goes up and trips my upper limit switch.
can someone give me a crash coursE?
-
IF a Z- move goes UP you have the z axis backwards to normal convention.
Just a thought, (;-) TP
-
What is the standard when it comes to g code? If you wanted to lower the spindle to the table would that be a positive z command or negative.
-
Negative IF zero is above the table top.
(;-) TP
-
Thank you BR549. I believe that is how i have it setup, but i just switched screen sets so that may have been lost in the settings? I will confirm.