Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fishmore on June 11, 2012, 04:49:03 PM
-
Hi,
I am new to to the forum and want to thank you for posting all your great knowledge.
I have been running Mach3 for a few months now and it's been great. But I have one issue, It doesn't remember my settings when I shut down. I am wondering if it should. All my zero references get lost. Is this typical?
-
There are options lower right in General config page for persistant DROs etc. Also make sure you have the last option unchecked (copy G54 from G59.253)
Hood
-
Thanks Hood,
But it didn't work. After shutting down Mach3 and restarting all four of my zeros start with very obscure numbers. I also have to click the reset button on each startup.
Fish
-
You always need to click the reset when you start Mach, it is that way for safety reasons.
If you attach your xml I will take a look and see if I can find a problem with your DRO readings.
Hood
-
Here is my xml file. Sorry for the delay, I got distracted with other issues.
I have another question. Does Mach3 support "Inverse Time"?
-
General Config page lower right, choose persistent offsets.
Hood
-
Thanks Hood,
That worked. This will make set up much easier.