Machsupport Forum
Mach Discussion => FAQs => Topic started by: Quin on June 10, 2012, 11:33:20 PM
-
when I initially start Mach3 and X home or Z home limit is made (2 axis machine), both mist and flood coolant comes on??
Quin
-
Hi Quin,
It is usual to have Mach turn off all outputs (as a safety precaution) when a stop is encountered. Perhaps changing the active state (High / Low) of the outputs you use for these functions may be the way forward (reconfiguring the logic switching of the connected devices).
Tweakie.
-
Thanks Tweakie,
Further details on the problem:
I load Mach3. If either X home or Z home limit is active, the flood and mist are energized after about a 2 sec delay. They can only be turned off by moving the X or Z on to the overtravel limit. When I come off the overtravel, they come back on. when I come off either home limit they stop. If I cycle the overtravel a couple of times, the problem clears and I can run a program normally with out further problem.
If I shut down Mach3 and restart, the problem returns.
Is this possibly a known bug in Mach3?
-
I think you may have the coolant setup with the same ports/ pins as the limits or homes. Check your config.
Just a thought(;-) TP