Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Otokoyama on February 05, 2006, 03:57:58 PM

Title: Setting Rapid (G00) Rate?
Post by: Otokoyama on February 05, 2006, 03:57:58 PM

I'm getting much faster rapids when jogging than when programming G00.  Is there some setting that I haven't been able to find that controls this?

Thanks. 

Title: Re: Setting Rapid (G00) Rate?
Post by: Art on February 05, 2006, 04:22:12 PM

Hi:

 The only way that can happen is if the G0 Rapid override on the settings page is turned on. Is yours?
That control limits the amount fo rapid speed in G0's. The Jogging runs to the full G0 speed..

Regards,
Art

Title: Re: Setting Rapid (G00) Rate?
Post by: Otokoyama on February 05, 2006, 04:43:37 PM

Hi Art,

It's Paul Yuenger.  I came over here to keep from bothering you too much via email, and here you are! 

I'm sorry, but I'm unable to find a dialog containing a "G0 Rapid Override" setting.  Which settings page is this on?

Thanks. 

Paul

Title: Re: Setting Rapid (G00) Rate?
Post by: Art on February 05, 2006, 05:35:03 PM

Hi Paul:

  Im all over. :)

  Its on the settings page, top left...

Art