Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: devlies on June 10, 2012, 05:54:00 AM
-
I have an twincat NC controller. It accepts G code. Are the following things possible
-sending actual G code command
-returning actual positions from twincat to mach3
-getting the jog commands, set zero commands from mach3
I have knowlegde to get those thing in twincat (by use of ads twincat protocol) but i lack knowledge of mach3 to know if it is posible
thanks a lot
Pieter Devlies