Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bladerunner on June 07, 2012, 07:12:55 AM
-
G-Day Folks!
I have a 4th axis and controller card...and would like to use it on my router....But My router uses a double motor and card plulling the gantry with the A slaved to the X
so how can it be done please?
Thanx
Haydn
-
Assuming you wish the 4th axis to be called A then all you would need to do is make the slaved axis the B or C.
Hood
-
Thanx I found that and was hoping it would be the case..so will give it a go ..
Thanx!
Haydn