Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: caddy on June 02, 2012, 08:14:20 PM
-
Hello:
I'm hoping someone has encountered this before and can guide me on how to resolve the issue:
When I purchased my machine, it was set up to home the full X+ and full Y+. I changed it to home at full X- and full Y_ . After that, the yellow/green Normal/abnormal light flashes at me all the time and when clicked on gives the message: axes not reffed to normal condition". Clearly this is from changing the homing position. I don't know how to tell the normal/abnormal light that the homing position has changed. Have any of you experienced this and if so, please advise me how to fix it. In return, I would offer to dance at your next wedding.................:)
Thanks for taking the time to read and respond. And oh yes, obviously I'm not the shapest knife in the drawer on Mach 3 ..........well DUH !!
-
Operator Menu > Set Normal Condition
-
THANK YOU GERRY !!!