Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ilkleyal on May 17, 2012, 08:07:02 AM
-
Hi
Sorry, I did say there would be many questions. ;D
I need to make a "pair" of components. Now, I realize that I can simply make one and then shift the machine zero points to another loaction on the table but is there a way I can just copy a complete component and place it next to the first one?
Using Cambam and Mach3
Many thanks if you can assist.
Al.
-
Have a look at the nesting wizard.
Hood
-
If you're using CAD/CAM surely you just copy and paste the part and generate the toolpath for both parts. (Sorry for calling you shirley ;D)
Ian
-
Why would you bother? Write the cutting part as a subroutine, use two fixtures, cut one part then change fixtures and cut again. Five minute job to code that.
-
Why would you bother? Write the cutting part as a subroutine, use two fixtures, cut one part then change fixtures and cut again. Five minute job to code that.
well the clue was in the original question
Using Cambam and Mach3
If your using CAM then it's a fair (100%) bet you're using CAD - so copy n paste - of course it depends how quick you're fingers can do a ctrl-c ctrl-v but I reckon about half a second with practice ;D
Ian