Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: antennas4u on May 08, 2012, 08:28:29 PM
-
Hi I'm a Newbie,
I have a fault in my home bulit CNC router. My machine drops out every couple of minutes on a "External E Stop Requested" fault. I run Mach3. Can anybody help me rectify this problem PLEASE ?
Regards
Terry
-
try raising the debounce interval in general config to 2000 or 3000
-
Thanyou very much for your quick reply. I have my debounce set at 2000, if I lift it by another 1000 do you think that will make a difference?
Regards Terry
-
it might