Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: spr203 on April 30, 2012, 03:46:09 PM
-
hi, got the machine running well . I'm using leadshine drivers with nema42 stepper motors . have a pmdx breakout board 126 . when moving in both x and y machine this move is just to get to next hole i'm not milling freezes and will not move . any help would be good . thanks this forum has been great .
-
Are you meaning the motors are stalling? Are you hearing a loud noise?
Hood
-
yes i hear a noise and yes they stall and the this has happened more often when i send it to zero the of course the dro shows zero but it is no were near zero . hope this helps
-
You have your acceleration and/or velocity set to high for your motors in motor tuning.
Hood
-
thanks will give that a try today .