Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: CWB449 on April 29, 2012, 10:57:28 AM
-
This is a new one on me
Mach 3 seems to run great until I close the program, it'll crash every time except in safe mode.
Has anyone had this problem before?
Here's what comes up.
The problem seems to be caused by the following file; atiok3x2.dll
PAGE_FAULT_IN_ONPAGED_ AREA
Tech. Info:
*** STOP: 0x00000050 (0xE2AB1F6E, 0x00000000, 0xBF193275, 0x00000001)
*** atiok3x2.dll - address BF193275 base at BF182000, DATESTAMP 4b738974
I'm running Windows XP Pro SP3
Dell Inspiron 600m Laptop
Intel (R) Pentium (R) M
Processor 1.60 GHz, 591 MHz
1.00 GB of Ram
Any help would be greatily appreciated.
-
Try updating (or roll back if you have recently updated) your graphics card drivers, seems that file is part of the ATI Rage drivers.
Hood