Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ben on April 27, 2012, 05:51:38 PM
-
I'm trying to get my probe to work again. In port and pins I have Index disabled and Probe enabled, assigned to port 1 pin 15 and active low.
When I touch it to the touch plate the led on the BOB flashes each time and on the settings page the "Port 1 Pins current
State" changes also, but the program won't respond. At one time this all worked (last year) so I'm checking the Gcode last.
Have I missed a setting somewhere? Should the Index or Digitize LED on the settings page light up? What's your thoughts?
Thanks, Ben
-
The digitize LED on the settings page should light up.
-
The pin LED says that Mach knows that pin 15 has a signal but doesn't realize that it's a probe, so it's not lighting the digitizing LED. So I think there is something
I've missed in the setup.
Ben
-
check you don't have emulated ticked.
-
WOW! Nice catch, that fixed it. Good job and thanks for the help.
Ben