Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mikemill on April 25, 2012, 07:56:46 AM
-
My SyilX3 is cutting elipses instead of circles, I am using a file that has worked before and double checked in the simulator, so I assume the problem lies with the machine.
I have attached the file and the xml
Can anyone help?
Thanks
Mike
-
Afraid the xml and code has not been attached, also if you can post a pic of what you are getting it would help. Could be backlash due to somethng coming loose or possibly loosing steps on an axis or maybe even some scaling on an axis.
Hood
-
Machine worked fine yesterday so I don't think its mechanical Will try attachments again
Mike
-
I shall have to eat my words, loose motor to ball screw coupling on x axis. all is now well
Thanks for promp reply
Regards
Mike
-
Good you found it :)
Hood