Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: macatoms on April 19, 2012, 12:57:35 PM
-
I can not get the engraving wizard that comes in mach to load code to my run screen?Before I had my mill on line I could get it to run a simulation but now that I have my machine on line I cant get it to load any g code.What am I doing wrong?THANKS Dave.
-
Sounds like you are not doing ALL the steps to complete the program before you try to post the code.
(;-) TP
-
Make sure you choose a font, and go over the entire screen with a fine tooth comb to make sure you're not missing any options that need to be selected.
-
Its strange I have run the simulations many times and they worked.I am going to spend some time on it tomorrow morning.I will do a step by step so maybe we can see what I have done wrong.Thanks Dave.