Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: acourtjester on April 11, 2012, 04:50:25 AM

Title: Plasma drive problem
Post by: acourtjester on April 11, 2012, 04:50:25 AM

Starting to tune my table and I ran into an odd thing.  I was setting up motor speed and other things and all was fine in mach 3 mill.  I though I should do the same in mach 3 plasma I checked the pins for motor control and set the same speed values in motor control and then turned on jog to check.  Well the X buttons moved the Z motor and Y motor was fine but Z buttons did nothing ( not able to move anything but the dro displayed movement).  I just moved from mill to plasma software and nothing else was changed.
All motor pins are the same in both software settings.   

I am using ver 2.58.  have you seen this or heard of it???

 

Thanks

Tom 

Title: Re: Plasma drive problem
Post by: markycski on April 15, 2012, 06:15:18 PM

Check your output enable pins had the same problem

Title: Re: Plasma drive problem
Post by: acourtjester on April 15, 2012, 11:22:02 PM

Thanks for the reply I downloaded the next ver (3.043)of software and do not have the problem with either plasma or mill settings.

hav fun
Tom