Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: boumac on April 08, 2012, 04:31:27 PM
-
I'm a newbie. Just getting my plasma table up and running. Bought it used and made some improvements. Upgraded from Mach 2 to Mach 3. If I choose plasma icon from my desktop I can jog X and Y but not Z. Display shows Z is moving but it isn't. Checked output pins etc. all good. If I plug Z cable into Y or X it runs fine. If I open Mach 3 Mill from the desktop icon all axes work well. Wondering if I need to download an d reinstall?????