Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Triblix on April 03, 2012, 06:06:45 PM
-
Good evening,
Does anyone know which OPC server I can use to connect to Mach3?
I tried to connect Mach3 to my SCADA solution through the Modbus Serial RTU (Connecting 2 PC's with a null modem) and Mach Brains, but was unsuccessful.
I am using Movicon11.3 software to create the SCADA solution.
Thank you in advance for the assistance.
Regards,
Tremaine
-
Were you able to find a solution for this? Thank you.