Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Farmerjeff on April 01, 2012, 01:15:09 PM

Title: Tool path display issue
Post by: Farmerjeff on April 01, 2012, 01:15:09 PM
Hey all,
I know it's Sunday so i would appriciate any and all help. I will be posting a few HELPs so many thanks to all. I have a DIY (moving table) and having a display issue. In the 'simulate program run, I can see the tool path, however in the display, I cannot see the tool moving around the tool path. How do I see this tool?
Thanks,

Jeff
Title: Re: Tool path display issue
Post by: Hood on April 01, 2012, 02:42:59 PM
There are settings you can try from Config menu then Toolpath. The show lines from current to last will likely be one you want enabled.
Hood